1. Required Tools and Materials
For this tutorial you will need:
- rings with an aspect ratio (AR = inside diameter – ID divided by the wire diameter – WD) of ~ 5.5 and up
- two pairs of pliers without teeth
I used rings with a wire diameter of 0.90 mm and an inner diameter of 5.10 mm.
2. Step by Step Process
Put 4 closed rings into one opened ring:
Close the ring and add another ring near him, going through the 4 rings:
Arrange them into a 2-2-2 chain:
Spread the rightmost 2 rings apart, as in the picture:
Pass an opened ring through the rings you’ve just unfold, going above the middle links and through through the leftmost ones. And close it :
Flip the piece over, on the other side, and add another ring, going the same as before:
Now spread the rightmost rings and slide another one in between them, through the “V” ones:
Add another ring near the last one, repeating the step:
Pass a ring through the last ones and through the “V” links:
Flip over the piece, on the other side, and repeat the step:
Again you spread the rightmost rings and slide 2 more rings in between them:
And the steps that follows, on each side:
Consider the spreading and adding step, followed by the rings on each side, as a cycle. And continue to repeat it:
3. Conclusion
Here is a fine silver full persian bracelet:
For the full model in the store, check out my Full Persian on Etsy.